Bages-Sigean and Canet-St Nazaire lagoons (France): physico-chemical characteristics and contaminant concentrations (Cu,Cd, PCBs and PBDEs) as environmental quality of water and sediment

Environmental characteristics in water and sediments of two contrasted coastal Mediterranean lagoons, Bages-Sigean and Canet-St Nazaire, were measured over a three season survey. The urban pollution (treatment plant discharges) is very important in Canet-St Nazaire lagoon reflecting untreated sewages, while in Bages-Sigean, the northern part appears more impacted due to larger anthropogenic inputs. Dissolved Cd concentrations are on the whole similar in both lagoons, whereas Cu concentrations are by far higher in lagoon Canet-St Nazaire. Cu concentrations appear to be highly dependent on dissolved organic carbon whereas salinity seems to control Cd variations. Concerning the sediments, the confined northern part of lagoon Bages-Sigean shows organic carbon and total nitrogen enrichment whereas lipid concentrations are much higher in the Canet-St Nazaire lagoon. Cu complexation seems to be strongly related to organic matter as evidenced by the two significant positive relationships, on one hand between Cu and organic carbon, and on the other hand, between Cu and lipids. On the contrary, Cd concentrations appear to be mainly controlled by carbonates. PCBs and PBDEs were detected only in sediments and show relatively low concentrations compared to similar lagoon environments. Regarding the sediment quality guidelines, Cd, Cu and PCBs in both lagoons did not exceed any Probable Effect Concentration (PEC).     

Emission,speciation, and evaluation of impacts of non-methane volatile organic compounds from open dump site

Surface emission from Dhapa, the only garbage disposal ground in Kolkata, is a matter of concern to the local environment and also fuels the issues of occupational and environmental health. Surface emission of the Dhapa landfill site was studied using a flux chamber measurement for nonmethane volatile organic compounds (NMVOCs). Eighteen noncarbonyl volatile organic compounds (VOCs) and 14 carbonyl VOCs, including suspected and known carcinogens, were found in appreciable concentrations. The concentrations of the target species in the flux chamber were found to be significantly higher for most of the species in summer than winter. Surface emission rate of landfill gas was estimated by using two different approaches to assess the applicability for an open landfill site. It was found that the emissions predicted using the model Land GEM version 3.02 is one to two orders less than the emission rate calculated from flux chamber measurement for the target species. Tropospheric ozone formation has a serious impact for NMVOC emission. The total ozone-forming potential (OFP) of the Dhapa dumping ground considering all target NMVOCs was estimated to be 4.9E+04 and 1.2E+05 g/day in winter and summer, respectively. Also, it was found that carbonyl VOCs play a more important role than noncarbonyl VOCs for tropospheric ozone formation. Cumulative cancer risk estimated for all the carcinogenic species was found to be 2792 for 1 million population, while the total noncancer hazard index (HI) was estimated to be 246 for the occupational exposure to different compounds from surface emission to the dump-site workers at Dhapa.

Implications:This paper describes the real-time surface emission of NMVOCs from an open municipal solid waste (MSW) dump site studied using a flux chamber. Our study findings indicate that while planning for new landfill site in tropical meteorology, real-time emission data must be considered, rather than relying on modeled data. The formation of tropospheric ozone from emitted NMVOC has also been studied. Our result shows how an open landfill site acts as a source and adds to the tropospheric ozone for the airshed of a metropolitan city.     

Economic assessment of flash co-pyrolysis of short rotation coppice and biopolymer waste streams

The disposal problem associated with phytoextraction of farmland polluted with heavy metals by means of willow requires a biomass conversion technique which meets both ecological and economical needs. Combustion and gasification of willow require special and costly flue gas treatment to avoid re-emission of the metals in the atmosphere, whereas flash pyrolysis mainly results in the production of (almost) metal free bio-oil with a relatively high water content. Flash co-pyrolysis of biomass and waste of biopolymers synergistically improves the characteristics of the pyrolysis process: e.g. reduction of the water content of the bio-oil, more bio-oil and less char production and an increase of the HHV of the oil. This research paper investigates the economic consequences of the synergistic effects of flash co-pyrolysis of 1:1 w/w ratio blends of willow and different biopolymer waste streams via cost-benefit analysis and Monte Carlo simulations taking into account uncertainties. In all cases economic opportunities of flash co-pyrolysis of biomass with biopolymer waste are improved compared to flash pyrolysis of pure willow. Of all the biopolymers under investigation, polyhydroxybutyrate (PHB) is the most promising, followed by Eastar, Biopearls, potato starch, polylactic acid (PLA), corn starch and Solanyl in order of decreasing profits. Taking into account uncertainties, flash co-pyrolysis is expected to be cheaper than composting biopolymer waste streams, except for corn starch. If uncertainty increases, composting also becomes more interesting than flash co-pyrolysis for waste of Solanyl. If the investment expenditure is 15% higher in practice than estimated, the preference for flash co-pyrolysis compared to composting biopolymer waste becomes less clear. Only when the system of green current certificates is dismissed, composting clearly is a much cheaper processing technique for disposing of biopolymer waste.     

Nitrogen critical loads and management alternatives for N-impacted ecosystems in California

Empirical critical loads for N deposition effects and maps showing areas projected to be in exceedance of the critical load (CL) are given for seven major vegetation types in California. Thirty-five percent of the land area for these vegetation types (99,639 km²) is estimated to be in excess of the N CL. Low CL values (3–8 kg N ha^?1 yr^?1) were determined for mixed conifer forests, chaparral and oak woodlands due to highly N-sensitive biota (lichens) and N-poor or low biomass vegetation in the case of coastal sage scrub (CSS), annual grassland, and desert scrub vegetation. At these N deposition critical loads the latter three ecosystem types are at risk of major vegetation type change because N enrichment favors invasion by exotic annual grasses. Fifty-four and forty-four percent of the area for CSS and grasslands are in exceedance of the CL for invasive grasses, while 53 and 41% of the chaparral and oak woodland areas are in exceedance of the CL for impacts on epiphytic lichen communities. Approximately 30% of the desert (based on invasive grasses and increased fire risk) and mixed conifer forest (based on lichen community changes) areas are in exceedance of the CL. These ecosystems are generally located further from emissions sources than many grasslands or CSS areas. By comparison, only 3–15% of the forested and chaparral land areas are estimated to be in exceedance of the NO₃^? leaching CL. The CL for incipient N saturation in mixed conifer forest catchments was 17 kg N ha^?1 yr^?1. In 10% of the CL exceedance areas for all seven vegetation types combined, the CL is exceeded by at least 10 kg N ha^?1 yr^?1, and in 27% of the exceedance areas the CL is exceeded by at least 5 kg N ha^?1 yr^?1. Management strategies for mitigating the effects of excess N are based on reducing N emissions and reducing site N capital through approaches such as biomass removal and prescribed fire or control of invasive grasses by mowing, selective herbicides, weeding or domestic animal grazing. Ultimately, decreases in N deposition are needed for long-term ecosystem protection and sustainability, and this is the only strategy that will protect epiphytic lichen communities.     

Element patterns in albatrosses and petrels: Influence of trophic position, foraging range, and prey type

We investigated the concentrations of 22 essential and non-essential elements among a community of Procellariiformes (and their prey) to identify the extent to which trophic position and foraging range governed element accumulation. Stable isotope analysis (SIA) was used to characterise trophic (δ¹⁵N) and spatial patterns (δ¹³C) among species. Few consistent patterns were observed in element distributions among species and diet appeared to be highly influential in some instances. Arsenic levels in seabird red blood cells correlated with δ¹⁵N and δ¹³C, demonstrating the importance of trophic position and foraging range for arsenic distribution. Arsenic concentrations in prey varied significantly across taxa, and in the strength of association with δ¹⁵N values (trophic level). In most instances, element patterns in Procellariiformes showed the clearest separation among species, indicating that a combination of prey selection and other complex species-specific characteristics (e.g. moult patterns) were generally more important determining factors than trophic level per se.     

No evidence for genetic differentiation between Antarctic limpet Nacella concinna morphotypes

The extent to which genetic divergence can occur in the absence of physical barriers to gene flow is currently one of the most controversial topics in evolutionary biology, with implications for our understanding of speciation, phenotypic plasticity and adaptive potential. This is illustrated by a recent study reporting a surprising pattern of genetic differentiation between intertidal and subtidal morphotypes of the broadcast-spawning Antarctic limpet Nacella concinna. To explore this further, we collected almost 400 Antarctic limpets from four depths (intertidal, 6, 15 and 25 m) at Adelaide island, Antarctica, and conducted a combined morphometric and genetic analysis using 168 polymorphic amplified fragment length polymorphism (AFLP) loci. Morphological analysis revealed not only pronounced differences between the two morphotypes, but also a continuous cline in shell shape from the intertidal zone down to 25 m depth, suggesting that the distinction between the morphotypes may be artificial. Moreover, genetic analysis using both F _st and a Bayesian analogue found no evidence for differentiation either between the two morphotypes or by depth, and a Bayesian cluster analysis did not detect any cryptic genetic structure. Our findings lend support to the notion that limpets can be phenotypically highly plastic, although further studies are required to determine unequivocally whether there is any genetic basis to the observed variation in shell morphology.     

How effective has the Clean Water Act been at reducing pollutant mass emissions to the Southern California Bight over the past 35 years?

The Clean Water Act (CWA) has regulated discharges of contaminants since 1972. However, evaluations of the CWA's effectiveness at improving regional water quality are lacking, primarily because integration of monitoring data from multiple dischargers to assess cumulative effects is not required. A rare opportunity exists to assess CWA effectiveness by integrating mass emissions data from all major sources of contaminants to the Southern California Bight from 1971 to 2000. While the coastal population grew by 56% and total effluent volume increased 31% since 1971, mass emissions of nearly all constituents decreased since passage of the CWA, most by greater than 65%. Publicly owned treatment works were the dominant point source of many contaminants, but also accounted for the greatest reductions in pollutant discharge since 1971. As point source treatment has improved, the relative contribution of non-point sources, such as storm water runoff has increased. Despite the increased importance of storm water discharges, regional monitoring and data compilation of this source is lacking, making it difficult to accurately assess trends in non-point source discharge.     

Identification of air pollutant sampling period using horizontal dilution potential

A new model is proposed for estimating horizontal dilution potential of an area using wind data. The mean wind speed and wind direction variation are used as a measure of linear and angular spread of pollutant in the atmosphere. The methodology is applied to monitored hourly wind data for each month of 1 year for wind data collected at Vadodara, Gujarat and monthly dilution potential is estimated. It is found that there is a gradual variation of horizontal dilution potential over a year with limited dilution during post monsoon period i.e., October and November and a high dilution in pre monsoon period i.e., May and June. This information can be used to design air quality sampling network and duration of sampling for source apportionment study. Air pollutant sampling during high dilution period can be carried out for identifying urban and rural dust and wind blown dust from mining activity. Air pollutant sampling during low dilution period can be carried out for capturing large amount of particulate matter from anthropogenic sources like elevated stack of furnace.     

Characterization and Properties of Hydrophilic Cellulose Acetate Propionate Derivative

The chemical modification of Acrylamidomethyl Cellulose Acetate Propionate (AMCAP) was carried out by radical addition of acrylic acid. The structural modification was confirmed with the aid of FTIR, MS and NMR techniques. Thermal properties of hydrophilic cellulose derivative (AMCAP–H₂O₂) such as glass transition (T_g 153 °C) and thermal stability (372.7 °C) were determined by DSC and TGA techniques, respectively. These thermal properties confirmed the introduction of carboxylic groups into AMCAP structure, which causes an impact in their properties. The AMCAP–H₂O₂ shows minor contact angle compared to AMCAP, giving a more hydrophilic characteristic, due to acrylic acid addition into the side chains of AMCAP polymer.     

Biological Effects of Carbon Monoxide vs. Whole Emissions from Engine with Catalyst

The introduction of oxidizing catalytic converters in the exhaust system of automobiles has been found to be effective in reducing carbon monoxide, total hydrocarbons, and some other components of tailpipe emissions. The utilization of these converters, however, has also caused further oxidation of sulfur compounds producing an increased amount of sulfur trioxide (SO₃) which yields sulfuric acid and sulfates.¹ Studies on the biological effects of these sulfur compounds are in progress in our laboratory and preliminary findings are reported separately. This paper compares the biological effects of exposure to whole emissions from engines with and without converter and exposure to carbon monoxide alone.